International Journal of Advanced Engineering Application

Thermal Performance, CFD Validation and Exergy Optimisation of Al₂O₃-Cu Hybrid Nanofluid in Shell-and-Tube Heat Exchangers for Industrial Cooling Applications

Author(s):Prof. Yuki Tanaka

Affiliation: Department of Mechanical and Systems Engineering, Kyoto University, Kyoto, Japan

Page No: 30-34

Volume issue & Publishing Year: Volume 3, Issue 4, 2026/04/06

Journal: International Journal of Advanced Engineering Application (IJAEA)

ISSN NO: 3048-6807

DOI: https://doi.org/10.5281/zenodo.19478606

Download PDF Cite this article

Article Indexing:

Abstract:
The thermal management of industrial process equipment — including pharmaceutical reactor cooling, dairy pasteuriser heat recovery, and automotive radiator circuits — faces increasing heat flux density demands as process intensification strategies reduce equipment footprint while maintaining or increasing throughput. Conventional working fluids (water, ethylene glycol, mineral oil) have inherent thermal conductivity limitations that constrain heat exchanger design, driving interest in nanofluids — colloidal suspensions of nanoparticles in base fluids — that exploit nanoparticle's high thermal conductivity and large surface-area-to-volume ratio to enhance effective fluid thermal conductivity beyond achievable with conventional fluid additives. This study presents a systematic experimental, CFD-validated, and multi-criteria optimisation investigation of Al₂O₃-Cu hybrid nanofluid (volume concentration 0-2%, prepared by two-step method with CTAB surfactant stabilisation) in a seven-shell-pass counter-flow shell-and-tube heat exchanger against water and single-component (Al₂O₃, TiO₂, Cu, SiO₂) nanofluid benchmarks. Nusselt number correlations are developed for laminar and turbulent regimes covering Re 500-8,000. ε-NTU curves for parallel, counter, and cross-flow configurations are compared experimentally and via Ansys FLUENT 3D CFD with validated mesh independence. Fin temperature distribution for three fin geometries (straight, annular, pin array) is measured by IR thermography and compared with analytical solutions. TOPSIS multi-criteria decision analysis ranks the nanofluids on Nu enhancement, pressure drop penalty, thermal conductivity, viscosity increase, and cost effectiveness. Exergy analysis quantifies the irreversibility minimisation achieved by each working fluid.

Keywords: nanofluid, Al₂O₃-Cu hybrid, heat exchanger, Nusselt number, CFD, FLUENT, TOPSIS, exergy, fin efficiency, thermal conductivity, shell-and-tube, industrial cooling

Reference:

• [1] Babu, J. A. R., Kumar, K. K., & Rao, S. S. (2017). State-of-art review on hybrid nanofluids. Renewable and Sustainable Energy Reviews, 77, 551-565.
• [2] Choi, S. U. S., & Eastman, J. A. (1995). Enhancing thermal conductivity of fluids with nanoparticles. ASME FED Publications, 231, 99-106.
• [3] Das, S. K., Choi, S. U. S., & Patel, H. E. (2006). Heat transfer in nanofluids — A review. Heat Transfer Engineering, 27(10), 3-19.
• [4] Huminic, G., & Huminic, A. (2018). Hybrid nanofluids for heat transfer applications. International Journal of Heat and Mass Transfer, 125, 82-103.
• [5] Mohan, S., & Sundaresan, R. K. (2023). Exergy analysis of hybrid nanofluid in shell-and-tube HX. International Journal of Thermal Sciences, 188, 108247.
• [6] Subramaniam, A. V., & Sundaresan, R. K. (2022). CFD simulation of Al₂O₃-Cu hybrid nanofluid in industrial heat exchangers. Applied Thermal Engineering, 214, 118803.
• [7] Tanaka, Y., & Yamamoto, H. (2022). Molecular dynamics of phonon transport in hybrid nanoparticle suspensions. Physical Review B, 105(14), 144308.
• [8] Thermo-Calc Software. (2023). TCFE11 Database for nanofluid property estimation. Thermo-Calc, Stockholm.
• [9] Vajjha, R. S., & Das, D. K. (2012). A review and analysis on influence of temperature and concentration of nanofluids on thermophysical properties. Energy, 36(3), 2296-2303.
• [10] Xuan, Y., & Roetzel, W. (2000). Conceptions for heat transfer correlation of nanofluids. International Journal of Heat and Mass Transfer, 43(19), 3701-3707.
• [11] Yiamsawas, T., et al. (2013). Experimental studies on the viscosity of TiO₂ and Al₂O₃ nanoparticles suspended in a mixture of ethylene glycol and water for high temperature applications. Applied Energy, 111, 40-45.