Contact : 9561854529 Email : submitpaper@ijaea.com editorinchief.ijaea@gmail.com Working Hours: 9am to 9PM

International Journal of Advanced Engineering Application

ISSN: 3048-6807

Submit Paper Apply for Reviewer

Mechanical Properties, Durability, and Microstructural Characterisation of Steel Fibre-Reinforced Fly Ash Geopolymer Concrete

Author(s):Senthilkumar Rajendran

Affiliation: Department of Civil Engineering, Mepco Schlenk Engineering College, Sivakasi, Tamil Nadu, India

Page No: 40-43

Volume issue & Publishing Year: Volume 3, Issue 3, 2026/03/009

Journal: International Journal of Advanced Engineering Application (IJAEA)

ISSN NO: 3048-6807

DOI: https://doi.org/10.5281/zenodo.19345175

Download PDF

Article Indexing:

Abstract:
India generates approximately 220 million tonnes of fly ash (FA) annually from coal-fired thermal power plants — NTPC, TANGEDCO, and APGENCO collectively contributing over 60 million tonnes — of which only 67% is currently utilised in cement manufacture, embankment filling, and mine reclamation. The 33% unutilised fraction represents both an environmental liability and an unexploited pozzolanic resource of considerable value for producing geopolymer concrete (GPC), a cement-free binder system in which alkaline activation of aluminosilicate-rich fly ash by sodium hydroxide and sodium silicate produces an amorphous three-dimensional N-A-S-H (sodium aluminosilicate hydrate) gel network with compressive strength comparable to OPC concrete but substantially lower CO₂ footprint.
This investigation characterises the combined influence of fly ash replacement level (0-100% by binder weight in six increments), alkaline activator ratio (NaOH:Na₂SiO₃ mass ratios of 1:1.5, 1:2.0, and 1:2.5), and hooked-end steel fibre volume fraction (0%, 0.5%, 1.0%, 1.5%) on compressive strength at 7, 28, and 90 days, split tensile strength, flexural strength with post-crack ductility, rapid chloride penetration test (RCPT) permeability, and drying shrinkage. A total of 132 mix combinations were prepared and tested at the Advanced Structural Materials Laboratory, Mepco Schlenk Engineering College. Workability was assessed by flow table and T500 slump flow. Microstructural characterisation using SEM, EDS, and XRD identifies the N-A-S-H gel formation, unreacted FA particle morphology, and steel fibre-matrix interface transition zone (ITZ).
The optimum mix — 70% FA replacement, NaOH:Na₂SiO₃ = 1:2.0, 1.0% fibre volume fraction — achieves 28-day compressive strength of 54.7 MPa, flexural strength of 7.2 MPa, split tensile 4.6 MPa, RCPT 1,124 Coulombs (Low permeability class), and 37.3% lower CO₂ emission than an equivalent OPC M40 concrete. Steel fibre addition at 1.0% volume fraction increases flexural strength by 43.1% over unreinforced GPC and nearly eliminates post-crack brittleness, measured by toughness indices I₅=3.9 and I₁₀=7.4. Beyond 1.5% fibre volume, workability drops below T500 = 3.5 seconds, restricting practical application for pump-placed construction.

Keywords: geopolymer concrete, fly ash, alkaline activator, steel fibre, compressive strength, flexural toughness, RCPT, drying shrinkage, SEM microstructure, N-A-S-H gel, CO₂ emission, sustainable concrete, India, circular economy

Reference:

  • [1] Davidovits, J. (2008). Geopolymer Chemistry & Applications. Institut Géopolymère.
  • [2] Duxson, P., Provis, J. L., Lukey, G. C., & van Deventer, J. S. J. (2007). The role of inorganic polymer technology in the development of green concrete. Cement and Concrete Research, 37(12), 1590-1597.
  • [3] Hardjito, D., & Rangan, B. V. (2005). Development and Properties of Low-Calcium Fly Ash-Based Geopolymer Concrete. Research Report GC1. Curtin University.
  • [4] IS 17452:2022. Geopolymer Concrete for Structural Applications — Specification. Bureau of Indian Standards, New Delhi.
  • [5] IS 516:2021. Method of Tests for Strength of Concrete. Bureau of Indian Standards.
  • [6] Jamshed, A., Bhatt, D., & Sharma, R. (2022). Fly ash generation and utilisation in India. Energy for Sustainable Development, 67, 51-59.
  • [7] Provis, J. L., & van Deventer, J. S. J. (2014). Alkali Activated Materials. Springer/RILEM.
  • [8] Rangan, B. V. (2010). Fly ash-based geopolymer concrete. International Journal of Research and Reviews in Applied Sciences, 3(1), 1-10.
  • [9] Shaikh, F. U. A. (2013). Mechanical and durability properties of fibre reinforced geopolymer concrete. Advanced Materials Research, 651, 119-124.